| UTD | Workshop Information | All Projects | Workshop Equipment | FaceBook | LinkedIn |

Injection Molding

A Galomb A-100 Benchtop Injection Molder is available.

A calibration sheet can be completed using the thermometer.

The technical data sheet must be fully reviewed and understood before using this molder.

Please see the collapsed lung project, where this was used.

For more information, please contact:

Dr. Dani Fadda, Professor of Practice, 972-883-4626, fadda@utdallas.edu
Mechanical Engineering Department
Engineering and Computer Science West (ECSW) Building
Erik Jonsson School of Engineering and Computer Science
The University of Texas at Dallas
800 W Campbell Road, Richardson TX 75080